Metals -> Aluminium alloy -> Aluminium wrought alloys Characteristics of the material D18 ( Д18 ).
Material : D18 ( Д18 ) Classification : Aluminium wrought alloys
Chemical composition in % of the material D18 ( Д18 ) . Fe Si Mn Ti Al Cu Mg Zn Impurity max 0.5 max 0.5 max 0.2 max 0.1 95 - 97.6 2.2 - 3 0.2 - 0.5 max 0.1 other, each 0.05; all 0.1
Comment: Al is a basis; the percentage of Al is given approximately. Mechanical properties under Т=20o С of the material D18 ( Д18 ) .
Assortment Dimension Direct. s в s T
d 5
y KCU Heat treatment - mm - MPa MPa % % kJ / m2 - Wire 300 170 24 50 Hardening
and ageing Wire 160 60 25 Annealing
Brinell hardness of the material D18 ( Д18 ) (quenching, ageing , HB 10 -1 = 70 MPa Brinell hardness of the material D18 ( Д18 ) (annealing) , HB 10 -1 = 38 MPa
Physical properties of the material D18 ( Д18 ) . T E 10- 5 a 10 6 l r C R 10 9 Grade MPa 1/Grade Watt/(m·Grade) kg/m3 J/(kg·Grade) Ohm·m 20 0.71 2760 39 100 23.4 172 922
Specification :
Mechanical properties : s в - Tensile strength , [MPa] s T - Yield stress, [MPa] d 5 - Specific elongation at fracture , [ % ] y - Reduction of area , [ % ] KCU - Impact strength , [ kJ / m2 ] HB - Brinell hardness , [MPa]
Physical properties : T - Test temperature , [Grade] E - Young modulus , [MPa] a - Coefficient of linear expansion
(range 20o - T ) , [1/Grade] l - Termal (heat) condition coefficient , [Watt/(m·Grade)] r - Density , [kg/m3 ] C - Specific heat
( range 20o - T ), [J/(kg·Grade)] R - Electrical resistance , [Ohm·m]
Top
© 2003 - 2009 All rights reserved. About program.
Информация взята с сайта Марочник стали и сплавов
© 2002 - 2009 Мосспецсталь. Все права защищены
