Metals -> Aluminium alloy -> Aluminium casting alloys Characteristics of the material VÀL10 ( ÂÀË10 ).
Material : VÀL10 ( ÂÀË10 ) Classification : Aluminium casting alloys
Chemical composition in % of the material VÀL10 ( ÂÀË10 ) . Fe Si Mn Ti Al Cu Mg Zn Cd max 0.15 max 0.1 0.35 - 0.8 0.15 - 0.3 93.1 - 94.93 4.5 - 5.1 max 0.05 max 0.1 0.07 - 0.3
Comment: Al is a basis; the percentage of Al is given approximately. Mechanical properties under Ò=20o Ñ of the material VÀL10 ( ÂÀË10 ) .
Assortment Dimension Direct. s â s T
d 5
y KCU Heat treatment - mm - MPa MPa % % kJ / m2 - sand (mould) casting 400-430 300-320 4-7 100-130 cast in a metal mould 500 400 4 200
Brinell hardness of the material VÀL10 ( ÂÀË10 ) , sand (mould) casting HB 10 -1 = 70 MPa Brinell hardness of the material VÀL10 ( ÂÀË10 ) , cast in a metal mould HB 10 -1 = 90 MPa
Physical properties of the material VÀL10 ( ÂÀË10 ) . T E 10- 5 a 10 6 l r C R 10 9 Grade MPa 1/Grade Watt/(m·Grade) kg/m3 J/(kg·Grade) Ohm·m 20 2800 100 25.1
Technological properties of the material VÀL10 ( ÂÀË10 ) . Linear shrinkage, % : 1.25
Specification :
Mechanical properties : s â - Tensile strength , [MPa] s T - Yield stress, [MPa] d 5 - Specific elongation at fracture , [ % ] y - Reduction of area , [ % ] KCU - Impact strength , [ kJ / m2 ] HB - Brinell hardness , [MPa]
Physical properties : T - Test temperature , [Grade] E - Young modulus , [MPa] a - Coefficient of linear expansion
(range 20o - T ) , [1/Grade] l - Termal (heat) condition coefficient , [Watt/(m·Grade)] r - Density , [kg/m3 ] C - Specific heat
( range 20o - T ), [J/(kg·Grade)] R - Electrical resistance , [Ohm·m]
Top
© 2003 - 2009 All rights reserved. About program.
Èíôîðìàöèÿ âçÿòà ñ ñàéòà Ìàðî÷íèê ñòàëè è ñïëàâîâ
© 2002 - 2009 Ìîññïåöñòàëü. Âñå ïðàâà çàùèùåíû
